Xerox Phaser 6700 - Loading Paper in Trays

Load Paper in Trays 2-6
• Pull out the required tray until it stops.
•Remove any paper in the tray that is a different size.
•
Slide the length and width guides out
•
Slide the length and width guides out
.
•Fan the stack of paper to release sheets that may be
stuck together, and then align the edges of the stack on
a level surface.
NOTE: Do not load paper above the Maximum Fill Line.
•
Adjust the length and width guides until they lightly
Adjust the length and width guides until they lightly
touch the edges of the stack.
•Close the tray.
•If the tray is set to the "Fully Adjustable" mode, a
t t t th i t d l ill b
promp
t t
o
se
t th
e
paper
s
i
ze,
ty
pe,
an
d
co
l
or
w
ill b
e
displayed. If necessary, modify the settings and then
select the [OK] button.
4