Xerox Versant 2100 - Fault Codes - Press

Suggested SolutionsProblem
• Run the Adjusting Automatic Density Uniformity routine.
• Create a custom stock and add to the Stock Library.
• From the Stock Library Manager, Advanced Stock Setup
screen, make adjustments to the Secondary Transfer
Voltage Adjustment setting and the Transfer Output
Adjustment for Trail Edge option. Run the job again.
• If necessary, continue to adjust the Secondary Transfer
Voltage Adjustment setting until the desired output is
achieved.
• If output is still unacceptable, contact the Customer
Support Center.
Trail edge of output contains dry
ink / toner deletions, density incon-
sistency, or is lacking in color
depth; this occurs mainly when
using heavier or lighter weight
stock
Related Topics:
Tips for Extending Fuser Life
Preventing Fuser Damage
Clean Fuser Assembly
Adjusting Automatic Density Uniformity
Replacing the Pressure Roll Cleaning Pad Assembly
Cleaning the ROS Windows
Replacing a Drum Cartridge
Removing the Fuser Module
Installing the Fuser Module
Fault Codes
Fault Codes - Press
If printing ended abnormally, or a malfunction occurred in the press, then a fault code
is displayed. If a fault code appears on the press screen and it is not listed in the table
below, or if a fault persists after following the listed solution, then contact your Xerox
Customer Support Center. If a fault code is displayed, all print data on the press as well
as print data stored in the system’s built-in memory is discarded.
Recommended solutionPossible causeFault codeFault Area
Power Off / On the press.
If error persists, contact the
Customer Support Center.
Fuser Assembly belt speed
fault
010-319Fuser Assembly
Xerox
®
Versant
®
2100 Press10-12
User Guide
Problem Solving