Xerox Versant 2100 - Page 122

Recommended SolutionPossible CauseFault CodeFault Area
1. Remove or clear any jammed
paper.
2. Replace and fan the paper in
tray.
3. Power Off / On the press.
4. If problem still persists, contact
the Customer Support Center.
General tray malfunc-
tion
178-217, 178-
218, 178-[224-
229], 178-230,
178-232, 178-
250, 178-251,
178-[260-281],
178-[285-291],
178-[293-294],
178-298
Trays 8, 9 and
Bypass
Close the front door / cover of the OHCF.OHCF Front Door
Open
178-304Trays 8 and 9
Replace the feed rolls; refer to Replacing
the OHCF Feed Rolls for the OHCF
(Trays 8 and 9)
An OHCF feed, nudger,
or retard roll is near
end of life
178-400 - 178-
405
Trays 8 and 9
1. Remove or clear any jammed
paper.
2. Replace and fan the paper in
tray.
3. Power Off / On the press.
4. If problem still persists, contact
the Customer Support Center.
Multiple feed of
sheets / paper jam
178-900 - 178-
904
Trays 8 and 9
Related Topics:
Replacing the Bypass Tray Feed Rolls for the OHCF (Trays 8 and 9)
Replacing the OHCF Feed Rolls for the OHCF (Trays 8 and 9)
Skew Adjustment Levers (Trays 8 and 9)
Fault Codes - Interface Module
This fault code table lists problems and suggested solutions that apply to the Interface
Module. If the problem persists after following all instructions, call your Xerox Customer
Support Center.
Recommended SolutionPossible CauseFault CodeFault Area
Open the Module front door.
Remove all sheets or pieces
from the jam clearance
areas. Close the front door.
Verify that the paper being
used is within specifications.
Paper Jam during feeding048-100 to 048-
107
Interface Mod-
ule
Xerox
®
Versant
®
2100 Press10-20
User Guide
Problem Solving