Xerox Versant 2100 - Page 123

Recommended SolutionPossible CauseFault CodeFault Area
Ensure door is fully closed.Module front door is open048-300Door
Power Off/On the press.
If error persists, contact the
Customer Support Center.
Decurler Sensor or Belt issue048-310, 048-311,
048-312, 048-313,
048-314, 048-315,
048-316
Decurler
Power Off/On the press.
If error persists, contact the
Customer Support Center.
Cooling fan failure048-317, 048-318,
048-319
Cooling
Ensure all jams are cleared;
Ensure all handles/levers are
returned to closed position;
Power Off/On the press
Communication failure or
connection failure
048-320 to 048-
324
Communica-
tion
Open the Module front door.
Remove all sheets or pieces
from all paper path areas.
Close the front door. Verify
that the paper being used is
within specifications.
Sheets remain in the paper
path area
048-900, 048-901,
048-903
Paper Path
Fault Codes - GBC AdvancedPunch
Fault codes for the GBC AdvancedPunch are displayed on the press User Interface /
Control Panel as an AdvancedPunch fault code.
RemedyCauseFault Code
1. Open AdvancedPunch front door
and look for a paper jam.
2. Remove any paper jam.
3. Close front door.
Jam is detected in the Advanced-
Punch.
040-100
040-101
040-900
040-901
Close front door of the AdvancedPunch.Front door of the Advanced-
Punch is not closed.
040-300
Install punch die set or fully insert it; close
front door.
The punch die set is missing or
not fully installed.
040-940
Install and / or fully insert punch container;
close front door.
Punch container is missing or
not fully installed.
040-941
Empty punch container and then reinstall
it.
Punch container is full.040-942
10-21Xerox
®
Versant
®
2100 Press
User Guide
Problem Solving