Xerox Versant 2100 - Page 124

RemedyCauseFault Code
Empty punch container and then reinstall
it.
Punch container is near full.140-700
Fault Codes - GBC AdvancedPunch Pro
Fault codes for the GBC AdvancedPunch Pro are displayed on the press User Interface
/ Control Panel.
RemedyCauseFault Code
1. Open AdvancedPunch Pro front
door and look for a paper jam; refer
to Clearing Paper Jams in the Ad-
vancedPunch Pro.
2. Remove any paper jam.
3. Close front door.
Jam is detected in the Advanced-
Punch Pro.
040-100
040-101
040-900
040-901
Close front door of the AdvancedPunch Pro.Front door of the Advanced-
Punch Pro is not closed.
040-300
Install punch die set or fully insert it; close
front door.
The punch die set is missing or
not fully installed.
040-940
Install and / or fully insert punch container;
close front door.
Punch chip container is missing
or not fully installed.
040-941
Empty punch container and then reinstall
it.
Punch chip container is full.040-942
Empty punch container and then reinstall
it.
Punch chip container is near full.140-700
Fault Codes - High Capacity Stacker
This fault code table lists problems and suggested solutions that apply to the High
Capacity Stacker (HCS).
Important
The press configuration can be installed with one or two stacker modules. If the press
includes two HCS modules, the prefix 049 identifies a fault in the first module and 149
identifies a fault in the second module.
Xerox
®
Versant
®
2100 Press10-22
User Guide
Problem Solving