• The Main Power switch located inside the Center Front Door. This switch is used
mainly by the Xerox Service Representative when servicing the press. In rare problem
solving cases, you may be directed to power off the press with this switch.
• The Power On / Off button located on the right side of the Control Panel. This button
is the primary way for you to switch on or off the press. It is used by the operator as
workflow requires.
Use the Power On / Off button to power ON or power OFF the press.
Important
Always use the Power On / Off button first, and then power off the Main Power Switch.
Power On / Off the Press
To switch on the press:
• Check that the Main Power switch behind the Center Front Door is On and then press
the Power On / Off button on top of the print engine to the ON position. The Ready
Indicator light displays green.
A screen message advises of a short wait while the fuser warms up and the press runs
a system check. You can set features for a job during this time and the printing process
will start automatically when the press is ready.
To switch off the press:
• Press the Power On / Off button on the print engine.
Note
Allow the press to remain off for a minimum of 10 seconds before switching on the
power again.
Xerox
®
Versant
®
2100 Press1-8
User Guide
Product Overview
To Next Page
Loading...
