Xerox Versant 2100 - Page 200

RemedyCauseFault Code
Empty punch container and then reinstall
it.
Punch chip container is full.040-942
Empty punch container and then reinstall
it.
Punch chip container is near full.140-700
AdvancedPunch Pro General Problems
RemedyProbable Cause
1. Check that the power cord is attached
to back of punch unit and that it is
plugged into the wall.
2. If the problem continues, contact the
Customer Support Center.
No power, will not punch
• Follow instructions on die set labels to
properly configure the die for a specific
sheet size.
• Also, refer to Die Set Configuration for more
information and instructions.
• If the problem continues, contact the Cus-
tomer Support Center.
Punched holes are not aligned with the edge
of the paper
1. Remove the die set and inspect the die
throat for any stuck paper chads.
2. Remove the paper chads.
Sheets are jamming repeatedly at the die set
area.
Ensure that the Punch Chip Container is fully
inserted.
If the problem continues, contact the Customer
Support Center.
Insert the Punch Chip Container message is
displayed on the User Display Panel (Advanced-
Punch Pro).
Die Set End of Life
If a die set is at the end of its life it will cause paper jams due to hanging paper chips.
This is a result of die plate wear and not pin wear (which cannot be corrected). When
this occurs, the die set must be replaced with a new one.
Note
Attempting to replace or sharpen pins will not correct the issue since the wear is in the
plates and therefore is not recommended.
Xerox
®
Versant
®
2100 Press14-24
User Guide
GBC AdvancedPunch Pro