Related Topics:
Finisher Consumable Supplies
Standard Finisher Plus Consumable Supplies
Checking the Status of Consumables
When a consumable is reaching the time it needs to be replaced, a message is displayed
on the Control Panel touch screen. This will indicate when it is time to order and/or install
a new consumable item. With some CRUs, the screen indicates that the press may
continue to run print jobs without immediately replacing the item. Otherwise, when it
is time to replace it, a message appears and the press stops running.
To check the status of your consumables:
1. Press the Home button on the Control Panel.
2. From the Home screen, notice the Supplies area showing a 1 to 100% indicator bar
of the remaining amount of dry ink / toner.
Remaining dry ink / toner is updated in 10% increments.
3. Press the Supply information button (i). The Supplies screen displays.
4. Under the Supplies pull-down, you can select Toner or Other Consumables to view
the status of each dry ink / toner cartridge, each drum cartridge, the OHCF feeder
rolls, and the Waste Dry Ink / Toner container (status is OK).
Note
Dry Ink / Toner yield projections are based on 7.5 percent area coverage per color (4
colors = 30 percent) at standardized conditions on A4 (8.5 x 11 in.) Xerox Digital Color
Xpressions+ 24 lb. (90 gsm) and Colotech Plus 90 gsm reference paper.
Note
If image quality (IQ) issues are on the output, refer to the problem solving chapter
of the user guide for specific IQ problems and their related corrective actions.
Related Topics:
Image Quality Problems
Replacing the Bypass Tray Feed Rolls for the OHCF (Trays 6 and
7)
Tip
The feed rolls for OHCF bypass tray should be replaced when experiencing frequent
multifeeds, single feeds, or blank prints in the stack of the output prints.
Use this procedure to replace the (OHCF) bypass tray feed rolls, which includes:
• Feed Roll
• Nudger Roll
• Retard Roll
9-5Xerox
®
Versant
®
2100 Press
User Guide
Maintenance
To Next Page
Loading...
