Note
After you replace all of the feed rolls, contact your system administrator who will reset
the High Frequency Service Item (HFSI) usage counter for these CRU components to
zero (0).
1. Locate and access the Bypass Tray on top of the OHCF.
2. Lift up and open the Bypass Tray cover to access the feed roll components.
3. Remove and replace the feed roll by squeezing the metal shaft and lifting out.
4. Remove and replace the nudger roll using the same technique.
Xerox
®
Versant
®
2100 Press9-6
User Guide
Maintenance
To Next Page
Loading...
