Getting Started
20 WorkCentre
®
5845/5855/5865/5875/5890
Getting Started Guide
8. Paper Tray 6: This is an optional high capacity paper tray. It is a dedicated tray used for A4 LEF
(8.5 x 11” LEF) size media. Optional kits are available to accommodate A3 (11 x 17”), 8.5 x 14” SEF
or A 4 SEF (8.5 x 11” SEF) media.
9. Tray 7 (Inserter): An optional paper tray. It is used to insert pre-printed sheets into copy sets. It is
not part of the printing process and cannot be used for imaging.
10. Offset Catch Tray: The optional offset catch tray delivers output collated or uncollated. Each set
or stack will be offset from the previous to enable easy separation.
11. Basic Office Finisher: This optional device stacks, collates, staples and offsets your output.
12. Office Finisher: This optional device stacks, collates, staples and offsets your output. Hole punch
kits can be installed with this finisher.
13. Office Finisher with Booklet Maker: This optional finisher creates booklets, collates, offsets, stacks
and staples your output. Hole punch kits can be installed with this finisher.
14. High Volume Finisher: This optional finisher collates, offsets, stacks and staples your output. Hole
punch kits can be installed with this finisher.
15. High Volume Finisher with Booklet Maker: This optional finisher creates booklets, collates,
offsets, stacks and staples your output. Tri-fold and Hole Punch kits can be installed with this
finisher.
16. Convenience Shelf: An optional shelf used for holding documents or the Convenience Stapler.
17. Convenience Stapler: Optional stapler used to staple sheets if there is no finisher, or to re-staple
originals after copying.
Note: SEF is Short Edge Feed (where the short edge of the paper is the leading edge when the
paper is fed into the device). LEF is Long Edge Feed (where the paper is oriented so that the long
edge is fed into the device first).
To Next Page
Loading...
