Getting Started
36 WorkCentre
®
5845/5855/5865/5875/5890
Getting Started Guide
Using the Energy Saver Option
Energy Saver ends the current session and keeps the device running on low power. When in Energy Saver
Mode, press the Power button to wake up the device.
1. Press the Power button on the control panel.
2. Select the Energy Saver button on the touch screen.
3. Select the Energy Saver button again to confirm that the device should go into the Energy Saver
state.
Note: When Energy Saver mode is confirmed the device will immediately enter Low Power mode.
If Sleep mode has been configured, the device will then enter Sleep mode after a specified period
of time.
Note: The Power button is illuminated when the device is in the Energy Saver state. A steady light
indicates the device is in Low Power mode. A flashing light indicates the device is in Sleep mode.
4. To re-activate the device when in Low Power or Sleep mode, press the Power button. The device
takes longer to recover from Sleep mode.
To Next Page
Loading...
