Xiaomi Mi Robot Vacuum - Status, Sleep, and Advanced Modes

15
Instructions
Fault Status
Sleep
The unit will automatically go to sleep aer 10 minutes of inactivity.
The indicator light will blink once every several seconds while the
unit is in sleep mode.
Press any buon to wake the unit from sleep mode.
Press any buons while the unit is operating to pause it.
Pausing
Note: Recharging the unit on the charging dock when it is currently paused
will finish its current cleaning operations.
Note:
The unit will not enter sleep mode while on the charging dock.
The sleep time is over 12 hours automatic shutdown
Note:
The unit will go to sleep if no actions have been taken for 10 minutes aer the
unit has entered fault status.
Placing the device on the charging dock while the unit is in fault status will
end its current cleaning operations.
The indicator light will start blinking red followed by a voice prompt
whenever a problem occurs as the unit is working
Instructions
Scheduled Cleaning
You can schedule a time for the unit to start cleaning from Mi
Home app. The main unit will automatically start cleaning at
the designated times and automatically return to charge at
the charging dock when finished.
Do Not Disturb Mode
The unit will not automatically start another cleaning task or
play any audio while in 'Do Not Disturb' and the indicator
light will also be dimmed. The factory seings that come
with the device have the hours 22:00-08:00 configured as
a 'Do Not Disturb' period. You can turn off Do Not Disturb
or modify itshours with Mi Home app.
Reseing the Wi-Fi
Cleaning Modes
You can select Quiet, Standard, and Strong cleaning modes
from Mi Home app. The default mode is Standard.
Should your mobile phone be unable to connect to the unit
due to the configuration of the router, the loss of a password,
and so on, then please open its upper cover to see the Wi-Fi
indicator while holding down the buon and buon
until a voice says ‘Reseing Wi-Fi’. Wait until the Wi-Fi
indicator slowly blinks red, which indicates a reset has occurred.
Press the buon to continue cleaning and press the buon to
return the unit to the charging dock and conclude its current cleaning
operations.