3.3 Installation and using environment
(1) Install requirements:
TH has four ferric mounting racks when out of factory, there are two square holes on the up, down
side of TH, use mounting rack to fix the TH with control cabinet.
In order to avoid TH temperature too high after long time working, please keep 10cm space on the
up/down and 5cm on the left/right side of the TH when installing.
(2) Install steps
Step1
Refer to the dimension in the former chapter to open a rectangle mounting hole in the
control cabinet
Step2
Add airproof circles in the airproof slot when installing
Step3
Insert the bottom of TH into the mounting hole of control cabinet
Step4
Insert the install rack into the fix hole of TH then tighten the screw
Step5
Connect TH and PLC with communication cable
NOTICE
(3) Environment
Please use TH series touch screen indoor.
Do not use TH in below environment:
Inflammable gas, steam, dust, fast vary temperature, high humidity ( it may cause moisture inside
TH).
Fixed bracket
Install panel
The communication cable can be offered by the supplier or made by user according to the
connection map, input +24V DC power to start working
To Next Page
Loading...