Step 4: When finished the adjustment, the result is as the following;
Adjustment process is end.
Adjustment process is failed. Please do again.
Repeat as the target moves around the screen
Calibrate the touch panel
Repeat as the target moves around the screen
Calibrate the touch panel
Calibrate the touch panel
Repeat as the target moves around the screen
Calibrate the touch panel
Repeat as the target moves around the screen
Calibrate the touch panel
Repeat as the target moves around the screen
Calibrate the touch panel
Repeat as the target moves around the screen
Calibrate the touch panel
Repeat as the target moves around the screen
（1）click the center of the cross
（2）click the center of the cross on the top
left
（3）click the center of the cross on the left
bottom
（4）click the center of the cross on the right
bottom
（5）click the center of the cross on the top
left to finish the adjust process.
If the adjustment process is end, please turn off the power of TH, then turn off the
DIP switch 3, then turn on the power again. Now you can use TH normally.
To Next Page
Loading...