Xinje TH765-M - Page 58

The operation steps:
Step 1: make sure the TH is connected to object device.
Step 2: click ON/OFF button to start the data collection in history data map
Step 3: click the data export button, the U disk device LED starts to flickering, it means the CSV file is
being produced, if the LED ends flicker, the export process has been finished.
The CSV data is shown as below:
<B> Data export in line mode
In industry system, HMI is seemed as control and monitor terminal. It can be used to set all kinds of
parameters directly. In order to check the history data, use data export function to complete the data
management.
In this example, using data export function to complete the parameters recording.
Purpose: realize parameters setting by data input button, and data export by data export button.
The process is shown as below:
Next, we will introduce how to make the project in two parts:
Part 1: input the parameters
Put the data input button
on the screen, change the address as the following:
PSW500 PSW501 PSW502 PSW503 PSW504
● Save in CSV format file
PSW500
PSW501
PSW502
PSW503
PSW504
● S
et the head address to
PSW500.
Realize by data input button
Data input 1
Data input 2
Data input 3
Data input 4
Data input 5
R
ealize by function
button/export CSV data
Data
export button