XR Series Wireless Arrays
4
4A-Direct Ceiling or Grid Mount without Mounting Plate
Suspended Ceiling Grid:
You may attach the XR-600 directly to a 15/16”
ceiling grid without using a mounting plate. There
are two ceiling grid tabs on the back of the XR-600,
indicated in blue in the photo. Simply twist these
onto the ceiling grid and proceed to Step 5 on page 9.
Direct Ceiling Mount:
To attach the XR-600 directly to the ceiling, use the
mounting holes on the back of the XR-600, indicated
in red in the photo.
You need two screws of an appropriate type for the
construction material at the mounting site. We
suggest max screw size #8, Pan Head type.
NOTE: The XR-600 must not be disassembled - do not remove the back of the AP to tighten the
screws after mounting.
1. Mark the location for the two mounting screws-3.5” (8.9 cm) apart, on center. You may
use the “Direct Mounting Template” on page 13.
2. Install two screws in the ceiling so that they protrude 1/8” (.32 cm) between the
mounting surface and the head of the screw.
3. Align the holes in the back of the XR-600 over the screws protruding from the ceiling.
Push the XR-600 chassis up on the screw heads and rotate the XR-600 to the right until it
locks on the screw heads.
4. Proceed to“Connect the Cables” on page 9.
4B-Suspended Ceiling Grid Mount with Mounting Plate
The following steps use a mounting plate, which offers ease of
dismount and a locking option for the AP.
NOTE: Steps 1 and 2 are only required if you wish to lock the XR-
600 to its mounting plate after it is installed.
1. Align the three holes in the locking plate over the
corresponding three holes in the XR-600 mounting plate.
= Ceiling Grid Clips
= Screw Mount Holes
To Next Page
Loading...
Need help?
General
