12
OR
d) Press and hold the STOP button until the lift begins to move briefly (up and
down), the new position is recorded.
7.3. Setting for IntermediatePosition (Projection level)
a) Turn on the projector and press UP/STOP or DOWN/STOP buttons to
position the lift to the level where the images are aligned perfectly on the
screen.
OR
b) Press and hold the STOP button until the lift begin to move briefly (up and
down), the new position is recorded. (Note: The lift must be completely
stopped in the position before setting.)
more than 4 seconds
c) To delete the intermittent position that previously recorded, press STOP
button, the lift will travel to the position that recorded.
To Next Page
Loading...