16
2) Wall Mount Switch
Should you need to control with wall mount switch, please follow the
instructions below to pair wall mount switch and the lift.
a) Press and hold the Programming button at the back of the hand held
transmitter ( remote control) until the lift begins to move briefly.
b) Press and hold “PROG” button on back of the wall switch until the lift begins
to move briefly. The setting is memorized by wall switch.
NOTE: Please visit the following link for video instructions on XLT scissor lift limit
settings.
http://www.youtube.com/watch?v=AfSyawTEtKU
10. Safety Brake
The scissor lift is implemented with safety brake which will prevent the lift to fall
down in case of failure occurs. At normal operation, the safety brake won’t work. If
the safety brake engaged, a safety switch cuts the power of the motor and prevent the
consequential damages and injuries.
NOTE:
After activation of accident, please engage qualified technician to re-adjust the
safety brake.
To Next Page
Loading...
Need help?
General