INSTRUCTION
EN
Note: Once the safety belt of some models is
pulled out a certain length, If you need to increase
the pull-out length, it will not be achieved.
In this case, the seat belt must be fully rolled up
and pulled out again to the required length.
Finally, check the safety seat to ensure it is firmly
fixed on the car seat.
To make sure that the car seat has been installed
correctly, please shake it before use.
If shaking or loosening is found, you must
retighten the safety belt until the safety seat is
stable.
Warning: the car safety belt must not be twisted
after installation.
6.1.2 Installed in Rearward Facing Position with
ISOFIX and Top Tether
Group 0+I(0-18kg)
Put the ISOFIX insert guide into the two ISOFIX
attachment points of your vehicle.
If you don't have ISOFIX insert guide, please
Ignore this step.
NOTE: The ISOFIX attachment points are located
between the surface and the backrest of the
vehicle seat.
Press the ISOFIX button to pull out the two
locking arms from the base bottom. Pull the
locking arm to and fro until you hear an audible
CLICK which indicates they are fully engaged.
And on both sides of the locking arms button turn
into green safety color.
To Next Page