INSTRUCTION
EN
Car Safety Belt—Diagonal Belt
Car Safety Belt—Lap Belt
ISOFIX Attachments
5.SAFETY SEAT USE METHOD
5.1 Install Location
5.1.1 When using as Universal categort (Group 0+ I II III),
this child restraint system is suitable for seatbelt
models equipped with a three-point retractor that
complies with ECE R16 and does not apply to models
only equipped with 2-point seat belts.
Correct/ Proper
Wrong/ Improper
When front the of the seat with opened
airbag, cannot install in this place.
Only with 3-point seat belt and ISOFIX attachments
can install in this place.
5.2 How to use the harness buckle
Make sure the right side is up.
Engage them before putting them into the harness
buckle, which should make a CLICK noise.
Pull shoulder straps to remove all slack from the
lap section ensuring that the hamess is lying flat
and the hamess buckle is locked.
Open the hamess buckle by pressing the red
button.
5.1.2 When using as Semi-Universal category
suitable for seat belt models equipped with the
three-point retractor that has passed the ECE R16
requirement and is not suitable for models only
equipped with 2-point seat belts. And only after
installed ISOFIX, then can use on it.
Hold the two buckle tongues together.
(Group 0+I II III), this child restraint system is
To Next Page
Loading...