To Next PageTo Next Page
Need help?Do you have a question about the Xomax XM-V417 and is the answer not in the manual?
General| Brand | Xomax |
|---|---|
| Model | XM-V417 |
| Category | Car Video System |
| Language | English |
Do not press with the finger; it may lead to image distortions, unit malfunctions and screen damages.
To avoid accidents, do not handle the unit while driving. Stop and park the vehicle safely first.
Read the manual carefully before installation. Professional installation is recommended.
Set loudness appropriately to hear exterior noises. High levels can damage hearing.
Do not open or repair the unit yourself. This can lead to electrocution or void warranty.
Use only 12 Volt on-board power supply. Connect the minus (-) to ground (GND) negative.
When replacing fuses, ensure the new fuse has the same properties, especially amperage.
Do not occlude vent holes to avoid heat generation and accumulation; otherwise, there is a danger of fire.
Ensure the vehicle temperature is between 0°C and +40°C. Do not turn on the unit if too cold or too hot.
Keep the unit clean using a soft, dry rag. For major soilings, use a slightly damp rag.
To avoid fire or electric shock, do not expose the unit to moist environments.
Refer to your vehicle's operating instructions for assistance in connecting the steering wheel remote control.
Disconnect the vehicle battery before installation. Ensure the unit is a SingleDIN size.
Do not cut or short-circuit cables. Ensure proper grounding and wiring according to the diagram.
Ensure negative speaker cables are connected correctly and never to the vehicle body.
Speakers should have 4-8 Ohm impedance. Ensure speakers are intact; damaged ones can impair the unit.
Isolate all cable junctions and endings with electrical tape. Lay and fixate cables properly.
Connect the red cable to the ignition switch if the vehicle lacks an 'ACC' position.
For flawless performance, the integration angle should be approximately +/- 30 degrees.
This section details the steps for installing the unit, starting with the installation frame.
Remove the installation frame, insert it into the car slot, and bend cogs outwards to fixate.
Connect the ISO cable first to the unit, then to the vehicle. Remember to connect the radio aerial.
You will need a spanner to unloose the fixation nut and 2 extraction keys to release the unit.
Insert extraction keys into dedicated recesses between the frame and unit housing, centered.
With keys inserted, press holding side-cogs outwards to release the unit from the frame.
Pull the unit out carefully. Disconnect all cables and remove installation accessories.
Diagram showing connections for radio aerial, amplifier, rear view camera, external display, and speakers.
Diagram illustrating ISO plug connections for radio aerial, power, ignition, and speakers.
Details pin assignments for Socket A (power supply) and Socket B (loud speakers).
Explains connections for rear view camera (REVERSE) and steering wheel remote control (SWC).
Solutions include checking battery film, battery charge, and infrared receiver blockage.
Often caused by incorrect ISO cable connection, particularly ignition and steady plus.
Solutions depend on antenna type (passive, active, diversity) and may require phantom power.
Caused by incorrect ISO cable connection. Interchange ignition plus and steady plus cables.
User information on recycling electric and electronic devices at municipal collection points.
Dispose of empty batteries at municipal collection points. Pollutant-containing batteries are labelled.
