Quick Reference Guide
DBALL/DBALL2-CHRYSLER3 Remote Start Ready (RSR) Installation
© 2016 Directed. All rights reserved.
1
2
3
Stop the vehicle in a safe parking spot
and put the gear in Park (P).
Press
remote start
button*
* Your aftermarket remote may differ from the model shown in the illustrations.
Stop & put vehicle in Park (P)
P
&
Exit vehicle with
Smart Key
Pit Stop Mode
The Pit Stop Mode feature is practical when you need to stop and run an errand, but
wish to keep the engine running.
Note: We recommend that you always lock the doors
of your vehicle when leaving it unattended.
It is now safe to leave the engine running and exit the
vehicle with the factory remote in hand.
Press the button to remote start the vehicle.*
PANIC
x2
x2
PANIC
x2
x2
Vehicle Takeover with Get In and Go*
4
3
1
Close the vehicle doors, hood and trunk, then press
the Remote Start button on the transmitter to start
the vehicle.**
2
Press the brake pedal, put the car
in gear and drive off.
Enter the vehicle, while making sure the
factory remote is inside with you.
Press the Unlock button on the factory
or aftermarket remote.**
Ready to
drive off
Press
remote start
button**
Press Unlock
button on
either remote**
OR
** Your aftermarket remote may differ from the model shown in the illustrations.
Enter vehicle
with key fob
GG
* Get In and Go connections required.
Get In and Go
Get In and Go is designed to provide users with easy takeover when
entering their Push-to-Start (PTS) equipped vehicle, once it has been
remote started.
Typically, users would have to remote start their vehicle, then get inside and press
the vehicle start button to perform a takeover. There is therefore a physical action
required to drive away. With Get In and Go technology, you simply remote start the
vehicle, unlock the doors, get in and go... Nothing to do but put the gear in drive and
enjoy your vehicle.
This unique feature monitors a variety of parameters such as the key fob, vehicle
speed sensor and door sensor, in order to perform takeover securily.
GG
Complete the following steps within 45 seconds
or the vehicle will shut down.
P
ANIC
x2
x2
Remote Start Ready (RSR)
Remote Start Ready (RSR) is a function that enables the interface
module to remote start the vehicle completely on its own.
Consequently, there is no need for an aftermarket or an OEM remote
starter in order to start the vehicle from a distance.
To Next Page
Loading...
Need help?
General
