What to do if unlock command is not working on my Xpresskit Automobile Accessories?
If the Xpresskit Automobile Accessories module doesn't flash after receiving the unlock command, it indicates that the signal wasn't received. In this case, check the connections between the bypass and the remote starter module.
What to do if Xpresskit Automobile Accessories bypass data is not detected?
If the bypass data isn't being detected by your Xpresskit Automobile Accessory, verify the bypass line connection. Ensure there's continuity between both sides of the cut wire, and that the ignition is turned ON. Also, confirm the battery was removed when turning the ignition ON.
Why is CAN not detected in my Xpresskit Automobile Accessories?
If the CAN is not being detected by your Xpresskit Automobile Accessory, check the Tan - Tan/Black wire connections. Try waking up the data bus by turning the ignition on and then try the process again.
How to troubleshoot Xpresskit Extender when the module has no power?
If the Xpresskit Extender module has no power, ensure the D2D harness is connected and that 12 Volts are present between the red and black wires. If the voltage is present, the module might be defective.
What to do if trunk command is not working on my Xpresskit DBALL Automobile Accessories?
If the Xpresskit Automobile Accessories module doesn't flash after receiving the trunk command, it means the signal wasn't received. Check the connections between the bypass and the remote starter module.
What to do if bypass not detected after 5 seconds when the ignition is ON in Xpresskit DBALL Automobile Accessories?
Check the bypass connection of your Xpresskit Automobile Accessories.
What to do if Xpresskit Extender is waiting to begin the programming sequence?
If the Xpresskit Extender displays 'Waiting to begin the programming sequence', ensure the correct programming procedure is being followed.
Why Xpresskit Extender shows PTS shutdown error?
If the Xpresskit Extender displays 'PTS shutdown error', the PTS output from the module was not activated due to safety protection.
What to do if my Xpresskit Extender ISO 2 is not detected?
If the Xpresskit Extender displays 'ISO 2 not detected', the Orange/Black wire did not detect the expected signal. Refer to 'Installation (wiring diagrams & vehicle wiring reference charts)' to check the connections.
What to do if my Xpresskit Extender J1850 is not detected?
If the Xpresskit Extender displays 'J1850 not detected', check the J1850 wire connection. Wake up the data bus by turning the ignition on and try again.
Lists the sections and page numbers within the manual.
Introduces SmartStart compatibility and its connection to the interface module.
Provides information on finding the OEM remote starter unit within the vehicle.
Details the procedure for a full factory reset of the module's settings.
Explains how to use the OEM lock button for remote start functionality.
Describes the EIPS feature for preventing unattended running of push-to-start vehicles.
General| Product Type | Interface Module |
|---|---|
| Functions | Door lock control, remote start, and other vehicle functions |
| Programming | Required for vehicle-specific configuration |
| Firmware | Updatable for enhanced features and compatibility |
| Connection | Direct connection to vehicle's data bus |
| Usage | Remote Start Integration, Security System Integration, Keyless Entry Integration |
| Function | Immobilizer Bypass, Data Communication |
To Next Page
