Xpresskit DBALL User Manual

Page 5
Installation Type 1b (without T-Harness)
Important!
The Hood Pin and Remote Start Safety Override Switch are mandatory safety devices, but are NOT supplied with the DBALL.
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
[1] STSW: Starter Switch Wire. Refer to the wiring reference chart on page 6 for wire colors and connections.
[2] This connection is only required when the EIPS (Engine Idle Protection System) feature is activated.
Diagnostic
Connector at OBDII
(connector side view)
1 8
169
RF
Prog. Button
LED
4
2
(-) Ground: Black: 14
(+) 12V: Red: 13
HS CAN High: Tan/Black: 3
HS CAN Low: Tan: 4
(+) 12V: Brown: 7
[1] (+) STSW Output: Yellow: 8
HS CAN Low:
pin 14
(+) 12V: pin 16
(-) Ground: pin 4
HS CAN High: pin 6
[1] (+) STSW: pin 4 or 6
White Connector
Back side on
Main body ECU
1 2 3
5 6 7
8 9 10 11 12 13
14
1
5 16 1 17 8
19
4
10
14 12
Hood Pin
Neutral Safety Switch
6: White/Black: (-) Hood
(-) Parking Lights: pin 18
White Connector
At headlight switch
12345678910
1112131415161720
19
18
(-) Push-to-Start: pin 7
1
5
4
3 1
811
12
10
9
14
6
13
2
ENGINE
START
STOP
7
Black
connector
Connection required only if PitStop/Idle
mode or EIPS is desired (see details in
Quick Reference Guide).
(connector side view)
(-) Parking Lights Output: Red/Black: 4
(-) Push-to-Start Output: Green/Black: 2
[2] (-) EIPS Fail Output: Black/White: 1
[2] EIPS to Horn:
pin 8
10
11
12987
1 2 3 4 5 6
Black Horn Connector
at the bottom of steering column
Note: Hood pin only required on
vehicle not equipped with a factory
hood pin.
You can connect to either a XL202
RFTD OR a SmartStart module.
Refer to the SmartStart/XL202
Installation Notes for more
information.
Refer to the Wiring Reference Chart section on page 6 for more information on specific wiring and connections.
DBALL/
DBALL2
Platform: DBALL/DBALL2
Firmware: TL1 Remote Start Ready (RSR) Installation
© 2015 Directed. All rights reserved.
Rev.: 20150709
Vehicles
2013 2012 2011 2010 2009 2008 2007 PK-Immobilizer Bypass-Data No Key Req'd DL-Arm Factory Security DL-Disarm Factory Security DL-Door Lock Control DL-Door Unlock DL-Driver Priority Unlock DL-Hatch Glass Release DL-Trunk / Hatch Release EIPS RS-Remote Start Ready RS-SmartStart RS-Tach / RPM Output SS-Entry Monitoring ALL Door Pins SS-Entry Monitoring Driver Door Pin SS-Entry Monitoring Hood Pin SS-Entry Monitoring Trunk/Hatch Pin SS-Factory Alarm Trigger Monitoring ST-Brake Status (foot brake) ST-Ignition Status
ES 350 (Smart Key) 2 2 2 2 2 2 • • • • • • • • • • • • • • • • • •
Camry (Smart Key) 2 2 2 2 2 • • • • • • • • • • • • • • • • • •
Camry Hybrid 2 2 2 2 2 • • • • • • • • • • • • • • • • • •
Corolla (Smart Key) 1 1 1 1 1 • • • • • • • • • • • • • • • • • •
Highlander (Smart Key) 2 2 2 2 2 2 • • • • • • • • • • • • • • • • • •
Highlander Hybrid 2 2 2 2 2 2 • • • • • • • • • • • • • • • • • •
RAV4 (Smart Key) 1 1 1 1 • • • • • • • • • • • • • • • • •
Legend:
PK: Transponder & Immobilizer Override
DL: OE Door Lock & Alarm Controls
EIPS: Engine Idle Protection System
RS: Remote Start & Engine Controls
SS: Integrated Security & Monitoring
ST: Function/Feature Status
Toyota
Lexus

Xpresskit DBALL Specifications

General

Brand	Xpresskit
Model	DBALL
Category	Automobile Accessories
Language	English