What does it mean when ISO 1 is not detected on Xpresskit Remote Starter?
The Yellow/Black wire did not detect the expected signal. Refer to "Installation (wiring diagrams & vehicle wiring reference charts)" to check the connections.
What to do if Xpresskit DBALL2 Automobile Accessories shows 'Bypass data not detected'?
If the Xpresskit Automobile Accessories module displays 'Bypass data not detected', check the bypass line connection. If multiple wires are used, ensure they are not inverted. Also, verify that the vehicle operates correctly with the factory key.
Why does my Xpresskit Remote Starter show Bypass calculation failed?
If your Xpresskit Remote Starter shows Bypass calculation failed, reset the module and try again. Ensure that the vehicle is equipped with an immobilizer. If it is, verify that you have the correct EMS COM and that your connection is secure.
What to do if bypass data is not detected on Xpresskit Control Unit?
Check the bypass line connection. If more than one wire is used, make sure they are not inverted. Ensure the vehicle still operates correctly using the factory key.
Why OBDII feature is not supported by Xpresskit Control Unit?
The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
What to do if CAN2 is not detected on Xpresskit DBALL2?
If CAN2 is not detected on your Xpresskit Automobile Accessories, check the CAN2 wire connections. Try waking up the data bus by turning the ignition on and then try again. Note that some installations don't require this connection; you can skip it by pressing the programming button 5 times.
What to do if Xpresskit Remote Starter bypass data is not detected?
Check the bypass line connection. If more than one wire is used, make sure they are not inverted. Ensure the vehicle still operates correctly using the factory key.
What to do if my Xpresskit Extender CAN1 is not detected?
If the Xpresskit Extender displays 'CAN1 not detected', check the CAN1 Tan and Tan/Black wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What to do if ISO 1 is not detected on Xpresskit Control Unit?
The Yellow/Black wire did not detect the expected signal. Refer to "Installation (wiring diagrams & vehicle wiring reference charts)" to check the connections.
What to do if Xpresskit DBALL2 Automobile Accessories shows 'MUX not detected'?
If the Xpresskit Automobile Accessories module displays 'MUX not detected', the Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to "Installation (wiring diagrams & vehicle wiring reference charts)" to check the connections.
Lists vehicles and features compatible with the DBALL2 module.
Detailed wiring information for Mazda models across installation types.
Instructions for programming the module using different methods.
Guide to configuring module features and options.
Guide to interpreting LED indicators and resolving issues.
Details the warranty terms and conditions for the product.
Provides quick guides for vehicle takeover and available commands.
General| Product Type | Data Bus Interface Module |
|---|---|
| Compatibility | Compatible with most vehicles |
| Functions | Remote start, door lock, and security system integration |
| Connections | Data bus connection |
| Firmware Updates | Yes, via USB |
| Display | LED indicators |
| Power Source | Vehicle's electrical system |
| Programming | Programmable via computer or handheld device |
To Next Page
