What to do if Xpresskit DBALL2 Automobile Accessories shows 'MUX not detected'?
If the Xpresskit Automobile Accessories module displays 'MUX not detected', the Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to "Installation (wiring diagrams & vehicle wiring reference charts)" to check the connections.
Why OBDII feature is not supported by Xpresskit Control Unit?
The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
Why is Xpresskit DBALL2 Automobile Accessories waiting to begin programming?
If the Xpresskit Automobile Accessories module displays 'Waiting to begin the programming sequence', ensure you are following the correct programming procedure.
What does GROUND OUT ON (GWR) command received mean for Xpresskit Remote Starter?
If the Xpresskit Remote Starter shows GROUND OUT ON (GWR) command received, this indicates that the Ground While Running (status) signal was either lost or never received by the module. The commands can originate from RF, D2D, or W2W.
What to do if Xpresskit Control Unit has no power?
First, ensure the D2D harness is properly connected and that 12 Volts are present between the red and black wires. If the voltage is present, the Xpresskit Control Unit module may be defective.
What to do if my Xpresskit Extender CAN2 is not detected?
If the Xpresskit Extender displays 'CAN2 not detected', check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What to do if the brake was not detected by Xpresskit Control Unit?
The brakes were not detected, which prevents the system from shutting down the vehicle.
What to do if Xpresskit Control Unit transponder functions were skipped?
If compatible and RXT mode is not desired or convenience features are needed, reset and reprogram the module.
What to do if Xpresskit Remote Starter bypass data is not detected?
Check the bypass line connection. If more than one wire is used, make sure they are not inverted. Ensure the vehicle still operates correctly using the factory key.
Why CAN1 not detected in Xpresskit Remote Starter?
Check the CAN1 Tan and Tan/Black wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
Lists vehicles and features compatible with the DBALL2 module.
Detailed wiring information for Mazda models across installation types.
Instructions for programming the module using different methods.
Guide to configuring module features and options.
Guide to interpreting LED indicators and resolving issues.
Details the warranty terms and conditions for the product.
Provides quick guides for vehicle takeover and available commands.
General| Product Type | Data Bus Interface Module |
|---|---|
| Compatibility | Compatible with most vehicles |
| Functions | Remote start, door lock, and security system integration |
| Connections | Data bus connection |
| Firmware Updates | Yes, via USB |
| Display | LED indicators |
| Power Source | Vehicle's electrical system |
| Programming | Programmable via computer or handheld device |
To Next Page
