To Next Page
D
davidwigginsSep 23, 2025
What to do if Xpresskit Control Unit Runsafe was not disabled?
- JJason RiceSep 23, 2025
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
What to do if Xpresskit Control Unit Runsafe was not disabled?
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
What to do if Xpresskit Control Unit PTS shutdown error?
The PTS output from the module was not activated due to safety protection.
What to do if Xpresskit Control Unit skip programming?
If the BCM programming still fails after making sure doors are unlocked, press on the programming button 5 times to skip this step.
How to troubleshoot Xpresskit Remote Starter when module has no power?
If your Xpresskit Remote Starter module has no power, begin by inspecting the power connections to ensure they are secure and properly connected. Also, verify that the ignition input is correctly connected.
What does START ON command received mean on Xpresskit Remote Starter?
If the Xpresskit Remote Starter shows START ON command received, it indicates that the start signal was not received by the module. In a W2W installation, this message will only appear if the ignition input wire is in use.
What does GROUND OUT ON (GWR) command received mean for Xpresskit Remote Starter?
If the Xpresskit Remote Starter shows GROUND OUT ON (GWR) command received, this indicates that the Ground While Running (status) signal was either lost or never received by the module. The commands can originate from RF, D2D, or W2W.
What to do if Xpresskit Remote Starter initialisation failed?
If your Xpresskit Remote Starter initialization failed, try resetting the module. If the second attempt fails after a complete Hard Reset, connect the module to Directechs.com and call Tech Support with the module ID in hand.
Why does my Xpresskit Remote Starter show Bypass calculation failed?
If your Xpresskit Remote Starter shows Bypass calculation failed, reset the module and try again. Ensure that the vehicle is equipped with an immobilizer. If it is, verify that you have the correct EMS COM and that your connection is secure.
Lists vehicles and features compatible with the DBALL2 module.
Detailed wiring information for Mazda models across installation types.
Instructions for programming the module using different methods.
Guide to configuring module features and options.
Guide to interpreting LED indicators and resolving issues.
Details the warranty terms and conditions for the product.
Provides quick guides for vehicle takeover and available commands.
General| Product Type | Data Bus Interface Module |
|---|---|
| Compatibility | Compatible with most vehicles |
| Functions | Remote start, door lock, and security system integration |
| Connections | Data bus connection |
| Firmware Updates | Yes, via USB |
| Display | LED indicators |
| Power Source | Vehicle's electrical system |
| Programming | Programmable via computer or handheld device |
