Xpresskit DBALL2 User Manual

Rev.: 20170926
Platform: DBALL2
Firmware: MA2
© 2017 Directed. All rights reserved.
Method 1 (using 1 key and Key2Go) - Recommended Method
1
Solid
Wait until the LED turns solid red.ON
Note: Installations without HS CAN connections 5 times on the programming button,press
the LED turns ON solid Orange and proceed to step 2.
You have successfully completed the programming sequence.module
The turns solid green, then turns once the module has been successfullyLED ON OFF
programmed.
Solid Green Off
&
Key OUT
OFF
START
ON
7
8
4
3
6
5
Turn removethe key to and it from the ignition barrel.OFF
Remove the / 2 from the vehicle and reconnect it to your computer. The web siteDBALL DBALL Directechs
will automatically recognize that you are moving on to the second phase of the programming sequence.
Select the method and click on .Submit Key2 RequestGO
Once the configuration is completed, reconnect the / 2 to the vehicle.DBALL DBALL The flashes orange.LED
Key OUT
OFF
START
ON
Flashes
2
Key IN
OFF
START
ON
Turn turnthe key to position then it to theOFF ON
position again. The flashes orange slowly.LED
&
Flashes
Orange (slowly)
&
Key IN
OFF
START
ON
&
Key IN
OFF
START
ON
Insert turnthe key into the ignition barrel and it to the position. TheON LED
flashes green.
Flashes
Green
Page 21

Xpresskit DBALL2 Specifications

General

Brand	Xpresskit
Model	DBALL2
Category	Automobile Accessories
Language	English