Xpresskit DBALL2 User Manual

Rev.: 20170926
Platform: DBALL2
Firmware: MA2
© 2017 Directed. All rights reserved.
Important: Make sure all doors are closed on the vehicle before executing the programming sequence.
Insert turnthe first key and it to the position, wait untilON
the security light turns , then it. TheOFF LEDremove
flashes green.
Insert turnthe second key and it to the position, waitON
until the security light turns , then it.OFF remove
The flashes orange.LED
1st Valid
Key IN
OFF
START
ON
2nd Valid
Key IN
OFF
START
ON
1st Valid
Key OUT
OFF
START
ON
2nd Valid
Key OUT
OFF
START
ON
The turns solid green for 3 seconds, then turnsLED ON OFF
once the module has been successfully programmed.
Release the programming button.
Solid
Green
OFF
Flashes
Orange
&
&
&
Release
Within seconds (if exceeded, restart programming at step 1, see page ):3 but no more than 10 seconds 12
Within seconds (if exceeded, restart programming at step 1, see page ):3 but no more than 10 seconds 12
&
OR
&
Press
and hold
button
&
Press
and hold
button
Remote Start
*
Ignition
+12V
Jumper wire
to +12V
Method 2 (using 2 keys)
You have successfully completed the programming sequence.module
Flashes
Green
&&
3
4
5
2
1
Solid
Wait until the LED turns solid red.ON
Note: Installations without HS CAN connections 5 times on the programming button,press
the LED turns ON solid Orange and proceed to step 2.
Automatic Transmission:
the module programming button and then remote startPress & hold
the vehicule using the transmitter (keep holding the programming
button).
Manual Transmission:
the module programming button and then applyPress & hold
(+)12 to the vehicle ignition wire with a jumper wire (keep holdingV
the programming button).
Page 22

Xpresskit DBALL2 Specifications

General

Brand	Xpresskit
Model	DBALL2
Category	Automobile Accessories
Language	English