2
Solid
&
Solid
Flashes
&
Release
3
Wait 3 seconds until the orange aitLED turns solid , and w 10 more secondsON
until the andLED starts to flash orange red.
Release the programming button. The turns solid red.LED ON
Warning gainst xecuting a Hard Reset!AE
A hard reset will revert the flashed firmware back to its default settings. Depending on the installation, some settings (such
as and D2D options) may have to be reconfigured. See the section of this guide.RFTD Feature & Option List
1
OR
If required for your installation, c , &onnect the 10-pin 12-pin
14-pin harnesses to the module Press hold the. and
p , then connect the 4-pin D2D harness.rogramming button
D2D Installation
If required for your installation, connect the 10-pin & 12-pin
harnesses to the module Press hold the rogramming. and p
button, then connect the 14-pin harness to the module.
W2W Installation
10-pin
D2D
1
st
12-pin
14-pin
2
nd
4
th
3
rd
10-pin
D2D
1
st
5
th
12-pin
14-pin
2
nd
3
rd
4
th
Module Reset
Hard Reset
2
& &
Solid Solid
Release
Wait 3 seconds until the orange then release theLED turns solidON
p The then turns solid red.rogramming button. LED ON
A module reset will only erase programming performed in the previous steps. All settings (firmware) and settings flashed
to the module using the web config tool will not be affected.
Page 23
1
OR
If required for your installation, c , &onnect the 10-pin 12-pin
14-pin harnesses to the module Press hold the. and
p , then connect the 4-pin D2D harness.rogramming button
D2D Installation
If required for your installation, connect the 10-pin & 12-pin
harnesses to the module Press hold the rogramming. and p
button, then connect the 14-pin harness to the module.
W2W Installation
10-pin
D2D
1
st
12-pin
14-pin
2
nd
4
th
3
rd
10-pin
D2D
1
st
5
th
12-pin
14-pin
2
nd
3
rd
4
th
Rev.: 20170926
Platform: DBALL2
Firmware: MA2
© 2017 Directed. All rights reserved.
To Next Page
Loading...
Need help?
General
