What to do if Xpresskit Control Unit has no power?
First, ensure the D2D harness is properly connected and that 12 Volts are present between the red and black wires. If the voltage is present, the Xpresskit Control Unit module may be defective.
What to do if my Xpresskit Extender CAN2 is not detected?
If the Xpresskit Extender displays 'CAN2 not detected', check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What to do if 3x OEM Lock Remote Start Activation was attempted when RFTD feature is disabled on Xpresskit Control Unit?
Activated from Web automatically when using RSR flash tool or can be done manually. Refer to feature programing section for more information.
What to do if Xpresskit Remote Starter bypass data is not detected?
Check the bypass line connection. If more than one wire is used, make sure they are not inverted. Ensure the vehicle still operates correctly using the factory key.
Why CAN1 not detected in Xpresskit Remote Starter?
Check the CAN1 Tan and Tan/Black wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
How to fix CAN2 not detected issue on Xpresskit Remote Starter?
Check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What causes J1850 not detected error in Xpresskit Remote Starter?
Check the J1850 wire connection. Wake up the data bus by turning the ignition on and try again.
Why Xpresskit Remote Starter says OBDII feature not supported?
If your Xpresskit Remote Starter displays 'OBDII feature not supported', this is because the diagnostic data bus was not detected. Some features are not supported by SmartStart due to missing wire connections or module hardware limitations. Refer to the wiring installation section to check the connections.
Why does my Xpresskit Remote Starter show Bypass calculation failed?
If your Xpresskit Remote Starter shows Bypass calculation failed, reset the module and try again. Ensure that the vehicle is equipped with an immobilizer. If it is, verify that you have the correct EMS COM and that your connection is secure.
What to do if my Xpresskit Extender CAN1 is not detected?
If the Xpresskit Extender displays 'CAN1 not detected', check the CAN1 Tan and Tan/Black wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
Lists vehicles and features compatible with the DBALL2 module.
Detailed wiring information for Mazda models across installation types.
Instructions for programming the module using different methods.
Guide to configuring module features and options.
Guide to interpreting LED indicators and resolving issues.
Details the warranty terms and conditions for the product.
Provides quick guides for vehicle takeover and available commands.
General| Product Type | Data Bus Interface Module |
|---|---|
| Compatibility | Compatible with most vehicles |
| Functions | Remote start, door lock, and security system integration |
| Connections | Data bus connection |
| Firmware Updates | Yes, via USB |
| Display | LED indicators |
| Power Source | Vehicle's electrical system |
| Programming | Programmable via computer or handheld device |
To Next Page
