Xpresskit DBALL2 Installation

Rev.: 20160608
Platform: DBALL/DBALL2
Firmware: CHRYSLER3 Remote Start Ready (RSR) Installation
© 2016 Directed. All rights reserved.
You have successfully completed the module programming sequence.
9
8
Click on Submit Key2GO Request.
Remove the DBALL from the vehicle and reconnect it to your computer. The Directechs web site will
automatically recognize that you are moving onto the second phase of the programming sequence.
Refer to the LED Diagnostics section for more information and for troubleshooting purposes.
Version 4.5 or higher of XpressVIP must be installed on your computer to complete this programming sequence.
Web Programming (for Key2GO)
7
Disconnect the module and complete the Key2GO procedure (see below).
Page 11
10
Once the configuration is completed, reconnect the module.
The LED turns solid green.
Solid Green
6
Press on the Start/Stop button (PTS) once to turn the ignition OFF.
to OFF
ENGINE
START
STOP
PUSH x1
to ON (RUN)
ENGINE
START
STOP
5
Press on the Start/Stop button (PTS) twice
to turn the ignition ON. The LED flashes orange slowly.
&
Flashes
Slowly
PUSH x2
PAN
IC
x2
x2

Xpresskit DBALL2 Specifications

General

Brand	Xpresskit
Model	DBALL2
Category	Automobile Accessories
Language	English