22
05
BAG
901304
362648
303455
303457
303803
302814
930306
303212
980210
305341
302663
303455
362648
303457
901302
901302
303433
302663
303212
305350-K
302253
301391
901305
305346
305394
305224
305328
362652
303123
302291
901304
362652
303127
303354
940510
303433
930306
901302
307221
362651
305350-K
901304
303122
362649
901304
902205
940510
305231
901302
305241
305241
902310
302364-M
303123
902205
940510
940510
901302
980210
305253
305254
362649
307321
305392
302363-M
305253
901302
#305242 DRIVE SHAFT REPLACEMENT
CAP 3.5MM - ORANGE - STRONG (4)
#307222 TITANIUM FRONT ARM PIVOT PIN (2)
#307322 TITANIUM REAR ARM PIVOT PIN (2)
UPRIGHTS
#303352 0° 2-HOLE MEDIUM OPTION
#303354 0° 2-HOLE HARD INCLUDED
#303360 0° 2-HOLE GRAPHITE OPTION
5. FRONT & REAR TRANSMISSION
301391 GRAPHITE BODY UPSTOP 2.0MM (2)
302253 COMPOSITE STEERING BLOCK - HARD
302291 STEEL STEERING BUSHING (2+2)
302363-M COMPOSITE C-HUB FOR BODY UPSTOP RIGHT - 4° DEG. - MEDIUM
302364-M COMPOSITE C-HUB FOR BODY UPSTOP LEFT - 4° DEG. - MEDIUM
302663 COMPOSITE BALL JOINT 4.9MM - OPEN - V2 (8)
302814 T4’20 ANTI-ROLL BAR FOR BALL-BEARINGS - FRONT 1.4 MM
303122 ALU SHIM 3x6x1.0MM (10)
303123 ALU SHIM 3x6x2.0MM (10)
303127 ALU SHIM 3x6x4.0MM (10)
303212 ALU ADJ. TURNBUCKLE M3 L/R 26 MM - SWISS 7075 T6 (2)
303354 COMPOSITE UPRIGHT 0° OUTBOARD TOE-IN - HARD
303433 ALU ANTI-ROLL BAR BUSHING - 6MM (2)
303455 COMPOSITE ANTI-ROLL BAR BALL JOINT 4.9 MM (4)
303457 BALL JOINT 4.9MM - EXTRA SHORT OPEN (4)
303803 ANTI-ROLL BAR FOR BALL BEARINGS - REAR 1.3 MM
305224 ECS (ES) DRIVE SHAFT 52MM FOR 2MM PIN - HUDY SPRING STEEL™ (1)
305231 DRIVE SHAFT COUPLING - HUDY SPRING STEEL™
305241 DRIVE SHAFT REPLACEMENT CAP 3.5 MM (4)
305253 ECS DRIVE SHAFT COUPLING FOR 2MM PIN - HUDY SPRING STEEL™
305254 ECS (ES) DRIVE SHAFT CASE FOR 2MM PIN - HUDY SPRING STEEL™
305328 ALU DRIVE SHAFT SWISS 7075 T6 - HARDCOATED - 50MM
305332 ECS ES (ES) DRIVE SHAFT 52MM - HUDY SPRING STEEL™ - SET
305341 DRIVE AXLE - LIGHTWEIGHT - HUDY SPRING STEEL™
305346 ECS DRIVE AXLE FOR 2MM PIN - HUDY SPRING STEEL™
305350-K ALU WHEEL HUB - BLACK (2)
305392 DRIVE SHAFT PIN 2 x 10 WITH FLAT SPOT (2)
305394 ECS DRIVE SHAFT PIN 2 x 9 WITH FLAT SPOT (2)
307221 FRONT ARM PIVOT PIN (2)
307321 REAR ARM PIVOT PIN (2)
362648 BALL END 4.9MM WITH THREAD 4MM (2)
362649 BALL END 4.9MM WITH THREAD 5MM (2)
362651 BALL END 4.9MM WITH THREAD 8MM (2)
362652 BALL END 4.9MM WITH THREAD 10MM (2)
901302 HEX SCREW SB M3x2.5 (10)
901304 HEX SCREW SB M3x4 (10)
901305 HEX SCREW SB M3x5 (10)
902205 HEX SCREW SH M2x5 (10)
902303 HEX SCREW SH M3x4 SMALL HEAD - STAINLESS (10)
902310 HEX SCREW SH M3x10 (10)
930306 BALL-BEARING 3x6x2.5 STEEL-SEALED - OILED (2)
940510 BALL-BEARING 5x10x4 RUBBER SEALED - OIL (2)
980210 PIN 2x10 (10)
#309002
SET OF CERAMIC
BALL-BEARINGS
(14)
#303212-O ALU TURNBUCKLE L/R
26mm ORANGE - SWISS 7075 T6 (2)
#303210 TURNBUCKLE M3 L/R 26mm
HUDY SPRING STEEL™ (2)
STEERING BLOCKS
#302252 MEDIUM OPTION
#302253 HARD INCLUDED
#302254 GRAPHITE OPTION
DRIVE SHAFTS
#305323 50mm STEEL
#305324 52mm STEEL
#305326 52mm ALU
#305332 52mm ECS
#305333 50mm ECS
902303
C-HUBS
#302363-M 4° RIGHT MEDIUM INCLUDED
#302364-M 4° LEFT MEDIUM INCLUDED
#302383-G 4° RIGHT GRAPHITE OPTION
#302384-G 4° LEFT GRAPHITE OPTION
#305409
#304972
#305308
#305309
#305138
#302202
ALU STEERING BLOCKS WITH GRAPHITE
EXTENSION PLATES - SET
#305409 CVD BB DRIVE SHAFT 50mm - SET -
HUDY Spring Steel™
#305308 ECS BB DRIVE SHAFT 52mm - SET
#305309 ECS BB DRIVE SHAFT 53mm - SET
To Next Page
Loading...
