Standard Features
Forced Convection Cooling
All Xtant “X” Series amplifiers employ forced convection cooling for thermal man+
agement, An on+board thermal sensing circuit regulates fan speed to maintain
optimum operating temperature, Please see “Dual Fan Circuit” on page # for
additional cooling options,
Fully Regulated PWM Power Supply
All Xtant “X” Series amplifiers feature a fully regulated* Pulse Width Modulated
power supply, This supply technology provides high efficiency and consistent out+
put performance even when battery voltage is less than optimum,
Crossover
A $!/!" dB per octave “Butterworth” filter network is standard on the x$(($
amplifier, Both Low Pass and High Pass frequency selection is via a $! pin
Frequency Module (SIP), The amplifier is shipped with &( Hz SIPs installed* $!
other frequencies are available from your Xtant Dealer, The crossover’s Low
Pass function is dedicated to the x$(($ while the High Pass or Bypass functions
are available at the RCA line outputs,
Balanced / Floating Input
When enabled* this circuitry helps to eliminate “system noise” associated with
“ground loops”, When combined with the input sensitivity adjustment* it allows
the x$(($ to accept up to $#V of input signal,
Modular Expansion Port
All X series amplifiers are supplied with a modular port(s) used for docking any
of Xtant’s signal processing modules,
Protection Circuitry
Both Thermal* Overcurrent and Low Voltage protection are incorporated into
the x$(($, In the event of a problem* the amplifier will reduce its power to main+
tain operation, In the case of Low Voltage* the amplifier will shut off when the
battery voltage falls to $$ Volts or less,
Status LEDs
Three LEDs* visible through the cover* indicate operational status of the X$(($
amplifier, The red LED illuminates when the amplifier is “ON”* the yellow LED
indicates that overcurrent protection is employed and the orange LED indicates
that the thermal protection circuit is operational,
English
Xtant X1001 Specifications
Frequency Response ) Hz to )(( Hz -/– ' dB
Number of Channels $
Watts per Channel @ "Ω $ x )((
Watts per Channel @ !Ω $ x $(((
Watts per Channel @ $Ω $ x $(((
Distortion (THD) 0 !1
Signal to Noise Ratio 2 &( dB
Damping Factor 2 !(( @ $(( Hz with "Ω Load
Input Sensitivity $(( mV to .,) V RMS Unbalanced
$(( mV to $# V RMS Balanced
Input to Line Output Gain ( dB -/– !( dB* Selectable in $( dB Steps
On+Board Crossover $! or !" dB per Octave “Butterworth”
Line Outputs: Yes* High Pass or Bypass Mode
Module Port(s) ! – Accessory
Power Supply Fully Regulated* Pulse Width Modulated
Operational Voltage $$ to $) Volts
Size (L x W x H) !(
$$
⁄$%” x $(
)
⁄$%” x !
'
⁄$%”
)!)mm x !%$mm x ))mm
Warranty Limited " Year Parts and Labor
Fusing Requires $!( amp
English
6 7
To Next Page
Loading...
