Need help?Do you have a question about the Xtant 2.2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| THD at Rated Power | 0.05% |
| Signal to Noise Ratio | 100dB |
| Damping Factor | 200 |
| Input Sensitivity | 200mV - 4V |
| Crossover Frequency | 50Hz |
Circuitry compensating for unwanted resonance frequencies caused by midbass or midrange speakers in vehicle kick panels or doors.
Provides high efficiency and consistent output performance, even with less than optimum battery voltage.
Allows selection of low-pass or high-pass frequency range for optimal amplifier performance.
Eliminates 'system noise' from ground loops and accepts up to 17V of input signal.
Incorporates thermal and overcurrent protection to maintain operation during issues.
Indicates operational status: ON (red), Overcurrent (yellow), Thermal (orange).
Features like High Level Adapters (HLA) to connect source units with speaker level outputs.
RCA type input connections for source units with output signal levels of 100mV-17V.
RCA type output connections send full range signals to additional amplifiers.
Switch to eliminate noise from ground loops and set proper input voltage range.
Fine-tunes input sensitivity of the amplifier to the source unit's output level.
Active Resonance Control level adjustment to improve mid-range sound quality.
Selects preferred frequency range for amplifier output: high-pass, low-pass, or full range.
Adjustable control for low-pass or high-pass frequency range, 40Hz-120Hz.
Adds up to 12dB of low frequency impact, centered at 45Hz.
Output terminals for proper speaker connections, with bridging warnings.
Main power connection for the amplifier, includes GND and +12V/REM connection points.
Step-by-step guide for safely installing the Xtant amplifier in a vehicle.
Selection for amplifier outputs: mid/tweeters (HP), woofers/subwoofers (LP), or full range (BP/Full).
Adjustable control for crossover frequencies between 40-120Hz for optimal speaker matching.
Setting for input sensitivity based on RCA (low level) or High Level Adapters (HLA).
Procedure to set input sensitivity by turning gain controls to minimize distortion.
Selectable boost level (0-12dB) to enhance bass performance, centered at 45Hz.
Level adjustment to reduce resonant frequencies and improve mid-range sound quality.
To Next Page
