EU100 Elliptical
7
Support Tube
2
Hardware Step 2
4 Allen Screws (#30)
4 Curved Washers
(#31)
Pre-assembled on
tension control knob:
1 Washer (#65)
1 Bolt (#66)
1. Turn the Tension Control Knob (17) to level 8. Connect
Tension Control Knob (17) with Lower Tension Cable (59),
connect Lower Sensor Wire (58) with Upper Sensor Wire (60).
2. Tighten Tension Control Knob with one Washer (65) and Bolt
(66).
3. Insert the Front Post (13) into the Main Frame (1), tighten with
four Allen Screws (30) and four Curved Washers (31).
To Next Page
Loading...
