EU100 Elliptical
13
Functions
Computer Operation
Remarks
Scan: Displays each function in sequence every 6 seconds. The display loop is Time -
Speed - Distance - Calories - Odometer - Pulse.
Time: Shows your elapsed workout time up to 99:00
Counts down from your preset target time to 00:00 during your workout
Speed: Displays the current speed up to 999 MILE.
Distance: Displays the cumulative distance traveled during your workout up to 999 mil
Counts down from your preset target time to 0.0 during your workout.
Calories: Displays the cumulative calories burned at any given time during your workout
up to 999 cal. Counts down from your preset target calorie to 0.0 cal.
Odometer Displays the total distance accumulated up to 9999 mile.
Pulse: The monitor will display the user’s current heart rate in beats per minute during
the workout. Both hands must hold the gripped pulse for a heart rate reading during your
workout.
Note: This is a rough guide used for comparison of different exercise sessions, which cannot be used for
medical purposes.
How to preset Time, Speed, Distance, Calories and Odometer.
1. Press the mode button until desired function is displayed.
2. Press the set button until your desired number is displayed.
3. Press the mode button to accept value.
4. Press mode button for few seconds until all numbers back to zero except ODO.
The computer will count down from your pre-set value once you start exercising.
The computer will beep to indicate the completion of your pre-set value. Press any button to
stop the beep and the computer will now start to count up.
If more than one value is preset, the rst to reach the value will sound the alarm. Once you
have stopped the alarm the next preset value will sound the alarm until you have reached all
preset values.
1. Computer requires two “AA” batteries
2. The computer will turn on automatically by pressing any key or when you start
pedaling.
3. The computer will turn off automatically if no signal is detected for around four
minutes.
4. If computer is illegible or partial segments appear, remove batteries and wait 15
seconds to re-install.
Removing the batteries will reset all values to zero.
To Next Page
Loading...
Need help?
General
