14
EU100 Elliptical
Maintenance
The safety of this produce can be maintained only if regular periodic checks are made. Most
checks can be performed once a week. However some checks should be made before each
workout, and are indicated as such below.
Checks
• Check that pedals are tight, pedals can work loose over time.
• Check that stabilizer bolts are tight, check before each workout this.
• Check that handlebar is secure, if not, tighten, check before each workout this.
• Should a part become defective, replace it immediately. Do not allow use of the equipment
until it has been repaired.
Cleaning
A damp cloth is sufcient to clean most surfaces of this unit. Be careful not to drip water on
the monitor. A mild liquid soap may be added if needed.
HOW TO ADJUST THE SEAT
The seat can be adjusted forward or backward to the position that is the most
comfortable. To adjust the seat, loosen the quick release knob, slide the seat to the
desired position and retighten the knob.
HOW TO MOVE THE EU100
To move the Hybrid Bike, grasp the stationary handlebar and pull back on the handle
until the Hybrid Bike can be moved on the front wheels. Carefully move the Hybrid Bike
to the desired location and then lower it. Before moving the machine, please make sure
that the top handlebars are on same position.
HOW TO LEVEL THE EU100
The bike is equipped with adjustable end caps. If the unit is wobbly, please turn the
leveling caps on the rear stabilizer to level the unit.
User Direction
To Next Page
Loading...
Need help?
General
