Xterra SB550 - Rear Handle Bars Assembly; Handlebar Installation

8
SB550 Fitness Bike
#71. 3/8” x 19mm
Flat Washer (4 pcs)
#80. 3/8”
Nyloc Nut (4 pcs)
#100. 3/8” x 3”
Hex Head Bolt (4 pcs)
2
Hardware Step 2
1. Install the Handlebars (6 & 7) to the Seat Carriage with four Hex Head
Bolts (100), Flat Washers (71) and Nyloc Nuts (80). Be careful that the
wires do not get pinched while assembling the handlebars. Connect
Cable (111) to the Front Port on the left side below the seat, and Cable
(112) to the Rear Port.
Rear Handle Bars