11
TIE-DOWN BRACKETS
The fridge comes with 4 handle tie-down brackets to
make securing to a fridge slide or to a vehicle using
adjustable straps easy (note straps to be sourced
separately).
The metal brackets clip into the bars to the sides of
the handles at each end of the fridge.
+ To insert, angle to lower part of the bracket
inward and push the bracket over the bar until it
clips in place and swings freely.
+ You can then feed your tie-down strap through
the slot in the bracket and through the tie-down
point on your fridge slide or vehicle.
+ Repeat for all 4 locations and tighten the
straps securely.
+ If you need to remove your fridge from your fridge
slide or vehicle, you can loosen the tie-down
straps (without fully removing them).
+ Then un-clip the tie-down brackets from the
fridge, leaving them with your straps attached to
the fridge slide or vehicle tie-down points.
+ To remove the tie-down brackets, place your
thumb on the body of the fridge above the bar and
using your fingers, rotate the bracket inward and
pull the bracket up and out via the slot away from
the fridge.
Tie-down straps and lower anchor
points/fridge slide need to be
sourced separately and sized
appropriately from the fridge size
and weight
To Next Page
Loading...
