9
CONTROL PANEL LOCK
+ Press and hold Control Lock button for 3 seconds
to lock or unlock the control. When the control
lock is activated, all buttons are disabled.
+ Once the Control Lock is selected, press any
button, the Control Lock indicator LED will flash
to indicate the control is locked.
+ When the power is turned off or if there is a
sudden loss of power, the control lock function will
retain its previous setting when power is restored.
USB-A AND USB-C SOCKETS
+ The DC cooler has 2 USB-A ports and 1 USB-C
which can be used to charge a phone or power
small items while the fridge is connected to a
power source.
+ Power output is 15W (5V/3A) max across the 3
sockets (i.e. 3 in use: 5W MAX each, 2 in use:
7.5W MAX each, 1 in use: 15W MAX).
NOTE: Ensure the sockets are protected from
water/dust by securely fitting the rubber plug when
not in use.
DO NOT use the sockets while wet.
SETTING ACTIVE BRIGHTNESS SLEEP
LOW
Panel LED’s will light at low brightness I
nternal LED light will light at low brightness
After 5 sec all LED’s will turn off except Power
MEDIUM
Panel LED’s will light at high brightness
Internal LED light will light at low brightness
After 20 sec all LED’s will turn off except Power
HIGH
Panel LED’s will light at high brightness
Internal LED light will light at high brightness
Sleep not active
MUTING SOUNDS
+ Once the unit is powered ON, press and hold
Power Mode and button to turn on or turn off
the buzzer sound function.
+ Default is ON.
+ When the unit is turned ON or OFF, there will
be a long beep sound.
+ When a function button is used correctly, there
will be a beep to indicate the selection is
activated.
+ When a function button is used incorrectly
or if the controls lock is enabled, there will be
two sounds of beeps to indicate the selection is
deactivated.
+ When the unit detects a fault, there will be a
warning beep for 4 seconds.
To Next Page
Loading...
