Follow the operating principles:
￮ Check the machine for damage every time before you use it. Do not operate it in any
way when any damage or defect is found.
￮ Ensure that the workspace is clean and flat. Note that the laser tube is made of glass
and is very fragile. If it is broken, the machine fails to work.
￮ Do not disassemble the machine or change its structure in any way without
authorization. Do not modify or decompile its operating system.
￮ Keep the operating area of the machine clean. Residues and chippings accumulated
during cutting and engraving are dangerous and may cause fire. Clean the machine
regularly.
￮ The machine works properly at the temperature of 0°C to 35°C and can be stored
properly at the temperature of 0°C to 45°C. Do not operate it at a temperature lower than
0°C.
2. Laser safety
xTool D1 has no protective cover. Do not touch the laser when operating the machine.
Follow the safety precautions:
￮ Do not operate the machine when any part of it is removed. Removing any part may
cause damage to the machine.
￮ Do not engrave or cut any material that contains PVC or vinyl (plastic materials are
not recommended). These materials (and other materials containing chlorine/chloride)
To Next Page
Loading...
Need help?
General
