Xtool D1 User Manual

Assemble xTool D1
1. Cut off the cable tie on the right plate.
2.
Fit the four side plates together on a desk or flat ground.
3.
Tighten screws at each joint of the plates to fix them together.
Note:
￮ Align a screw with the screw hole before tightening it.
￮ Before you tighten the screws, press each joint of the plates to make sure that no
support hangs in the air.

Xtool D1 Specifications

General

Working Current	5A
Laser Power	10W
Engraving Speed	10000mm/min
Supported Materials	Wood, Leather, Paper, Plastic
Software Compatibility	LightBurn
Connectivity	USB, Wi-Fi
Focus Adjustment	Fixed focus laser (adjust focus by adjusting the height of the laser)