Xtool D1 User Manual

4.
Use screws to the set the tightness of the timing belts on the left and right plates.
Note:
￮ The longest screws are used to set the tightness of the timing belts. Do not fully
tighten them. Otherwise, the timing belts may be damaged.
￮ Make sure that you set the timing belts on the left and right plates with the same
tightness. Otherwise, materials can't be engraved properly.
5. Fit the middle plate.

Xtool D1 Specifications

General

Working Current	5A
Laser Power	10W
Engraving Speed	10000mm/min
Supported Materials	Wood, Leather, Paper, Plastic
Software Compatibility	LightBurn
Connectivity	USB, Wi-Fi
Focus Adjustment	Fixed focus laser (adjust focus by adjusting the height of the laser)