76
Figure 5-26 Sample of gearbox matching function (screen 1)
5. Wait until the message ‘Successful operation’ popes up.
5.9 GEAR LEARNING
The crankshaft position sensor learns crankshaft tooth machining
tolerance and saves to the tablet to more accurately diagnose
engine misfires. If gear learning is not performed for a car
equipped with a Delphi engine, the MIL turns on after the engine
is started. The diagnostic device detects the DTC P1336 'Gear not
learned'. In this case, you must use the diagnostic device to
perform gear learning for the car. After gear learning is successful,
To Next Page
Loading...
