MIL turns off. This function can complete the self-learning of the gearbox
and improve the quality of shifting.
After the engine ECU, crankshaft position sensor, or crankshaft flywheel is
replaced, or the DTC 'gear not learned' is present, gear learning must be
performed.
The operation guidelines of the Gear learning function are shown as
below:
1. Enter the Gear learning menu and choose relevant models
according to the vehicle being tested.
2. Turn on the ignition switch to start the vehicle.
3. Enter the Tooth Learning menu.
Read carefully and complete the requisites listed before performing the
gear learning function. And press OK after completing the instructions
shown
4. Read the instructions displayed and press Yes to start the learning
process.
To Next Page
Loading...
Need help?
General