Operation Manual
41
Operator Cab
Operation Manual
41
Boom Control
The boom control handle has variable motions from the
center position that control boom and tilt functions.
The boom control handle is used to raise, lower, extend,
retract the boom, tilt the carriage (or attachment), and
control auxiliary functions (when equipped with a carriage or
attachment with additional functions).
NOTE: The boom control handle is a variable speed control.
Function speed is proportional to handle movement. The
more the handle is moved in the appropriate direction, the
faster the corresponding function will occur.
NOTE: Increasing engine speed can increase boom lift and
extend speed.
NOTE: Two (2) boom functions can be performed at the
same time by moving the handle into the corner between (2)
functions
Figure 41. Boom Control Handle
• When the Declutch switch is set to OFF, the transmission
remains engaged when the travel select lever is set to
either FORWARD or REVERSE.
Figure 40. Declutch Indicator / Declutch Switch
Boom Control Handle Functions
Function Purpose
Aux Select Button Control auxiliary functions
Enable Trigger Trigger must be enabled for other
functions of the control handle to
operate
Tilt Switch Control carriage tilt (up/down)
To Next Page
