Operation Manual
52
Operation
Operation Manual
52
Normal Starting
Starting Forklift
Warning
To prevent death, serious injury, or property
damage, the operator must be seated with
seat belt fastened, arms, legs, and head com-
pletely inside the Rollover Protection Struc-
ture/Falling Object Protection Structure
(ROPS/FOPS), the travel select lever in NEUTRAL, and the
Parking Brake switch ON (engaged) BEFORE starting the
forklift.
1. Place Key in Ignition Switch.
Figure 61. Key and Ignition Switch
2. Turn key in ignition switch clockwise to the START position.
Figure 62. Turn Key in Ignition Switch to START
Caution
Release the key immediately once the motor starts. If the
motor does not start, DO NOT crank the starter motor con-
tinuously for more than 15 seconds. Failure to release the
key after the motor has started or continuous cranking can
damage the starter motor.
3. Release key immediately after the engine starts. The
Ignition Switch will automatically return to RUN.
NOTE: The Start position is spring-loaded. When the key is
released, the ignition switch will automatically return to the
RUN position.
Figure 63. Ignition Switch Automatically Returns to RUN
NOTE: If the engine fails to start on the rst try, wait until the
engine and starter come to a complete stop before cranking
the engine again.
4. After the engine starts, allow the engine to idle for
approximately 60 seconds.
5. Apply the service brake pedal and disengage the Parking
Brake switch.
To Next Page
