-18-
TIPS:
The camera can only connect to one device at a time.
The Wi-Fi connection is a little bit power-consuming, so
please avoidconnecting Wi-Fi when the battery power is
low.
The original Wi-Fi
password is 12345678
. If you want
to change it, go into
Settings - WiFi - WiFi Password
to
set a new password.
When the WiFi is connected, some functions and settings
on the camera are temporarily unavailable.
Step 2:
Swipe down on the screen with your finger after
powering the camera on to find the Wi-Fi mark. Choose it
and it will show the Wi-Fi name and password.
Step 3:
Find and connect the Wi-Fi in the Wi-Fi list on
your phone with the Wi-Fi name and password displayed
on the camera.
Step 4:
Open the XTU GO app on your smart phone or
tablet after the Wi-Fi is connected, you’ ll find the
camera is controlled by your phone.
Following are the available functions and settings:
1. Swipe down on touch screen to access Shortcut menu.
2. Swipe up on touch screen or press Power Button to switch
capturing modes.
3. Press Mode Button to access current mode settings.
4. Press Shutter Button to take a photo or record video.
To Next Page
Loading...