Need help?Do you have a question about the XTZ EDGE A2-300 and is the answer not in the manual?
General| Signal-to-Noise Ratio | >100dB |
|---|---|
| Total Harmonic Distortion | <0.05% |
| Input Sensitivity | 1.4V |
| Inputs | RCA, XLR |
| Damping Factor | >200 |
| Power Output | 2 x 150W @ 8Ω, 2 x 300W @ 4Ω |
| Frequency Response | 20Hz - 20kHz |
| Outputs | Binding posts |
Emphasizes reading the manual and contacting support for assistance.
Provides initial setup steps, including connecting speakers and power.
Instructions for connecting to AC power outlet; unit auto-detects voltage.
Recommendations for connecting cables, managing noise, and ensuring proper phasing.
Lists registered trademarks, including ICEpower and XTZ.
Instructions for cleaning the device with a soft, dry cloth after powering off.
Details on AC power inlet, fuse replacement, and main power switch.
Description of RCA inputs, gain control, and speaker output connectors.
Explanation of stereo mode (separate channels) and mono mode (summed channels).
Details on Auto ON (signal-dependent) and Always ON modes.
How soft furnishings affect mid/high frequencies and sound clarity.
How placement near walls/corners amplifies low frequencies, affecting clarity.
Awareness of furniture vibration affecting sound at loud bass levels.
Avoiding quadratic rooms or rooms with 2:1 length/width ratios to prevent resonances.
Importance of short, good quality cables to minimize noise and interference.
Amplifier stays on with signal, enters standby mode after ~8 minutes without signal.
Unit consumes <0.3W in standby, powers on with signal, enters standby without signal.
Red LED indicates standby mode; Green LED indicates device is ON.
Adjusts gain for sources, balances volume for bi-amping, limits max power output.
Mono mode sums L/R inputs to both outputs; Stereo mode keeps channels separate.
To Next Page
